Mallory-ignition Lakewood Subframe Connector 30401 Bedienungsanleitung PDF herunterladen

FORM 97146783 12/10

INSTALLATION INSTRUCTIONS

2010 Challenger Subframe Connector Part No. 30401

STEP 1

Properly raise and secure vehicle on either a drive-on

automotive lift or place all four wheels onto ramps which

are positioned on a level plane to prevent any twisting of

the uni-body prior to installation of sub-frame connector.

STEP 2

Identify right and left side sub-frame connectors and all

mounting points on vehicle.

STEP 3

Remove plastic splash panels from underside of vehicle

which attach to front wheel inner fender well. Also,

remove rear vehicle jacking point and plastic splash

panel at this location as well.

NOTE: if you are reinstalling splash panels after completion

of sub-frame installation some modiﬁcations to panels are

required.

STEP 4

Position sub-frame connectors into place and attach to

vehicle using the supplied hardware. The 8mm x 1.25 x 25mm

bolt and washers are used at the jack point location

whereas the sheet metal screw is used at the forward

mounting location. Welding of this product to the vehicle

is required. Bolting the sub frame connector to vehicle is

only for locating product prior to ﬁnal welding operation.

Welding of this sub frame connector to the vehicle is

required for proper installation.

CAUTION! Welding should be performed by a trained or

competent operator. All welding safety precautions should

be followed when welding on this or any vehicle. Be certain to

check for fuel or fuel vapor leaks prior to welding on this or any

vehicle. Keep a short current loop by placing ground clamp as

close to work as possible. Disconnect negative battery cable.

STEP 5

Fully weld sub frame connector to vehicle at all contact

points between body of vehicle and connector brackets.

LAKEWOOD IS A TRADEMARK OF PRESTOLITE PERFORMANCE

10601 MEMPHIS AVE #12, CLEVELAND, OH 44144

216.688.8300 FAX 216.688.8306

FORM 97146783

12/10

Printed in U.S.A.

Thank you for your purchase from Lakewood Industries.

For technical assistance, please call 216-688-8300

Monday thru Friday 8:30 AM to 5:00 PM EST.

WARNING: DUE TO THE TECHNICAL NATURE OF THIS PRODUCT,

AND SPECIALIZED EQUIPMENT, PROFESSIONAL INSTALLATION IS

RECOMMENDED.

CAUTION: INSTALLATION OF THIS PRODUCT REQUIRES WORKING

UNDER THE VEHICLE.IT IS THE RESPONSIBILITY OF THE INSTALLER

TO ENSURE A SAFE WORKING ENVIRONMENT.THE USE OF AN

AUTOMOTIVE LIFT IS RECOMMENDED. MAKE SURE THAT THE

VEHICLE IS SAFELY SUPPORTED AND ALWAYS USE JACK STANDS.

ALWAYS WEAR SAFETY GLASSES.

INSTALLATION INSTRUCTIONS 1

Inhaltsverzeichnis

Seite 1 - INSTALLATION INSTRUCTIONS

FORM 97146783 12/10INSTALLATION INSTRUCTIONS2010 Challenger Subframe Connector Part No. 30401STEP 1Properly raise and secure vehicle on either a drive

Kommentare zu diesen Handbüchern

Keine Kommentare

Mallory-ignition Lakewood Subframe Connector 30401 Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Für das Auto Mallory-ignition Lakewood Subframe Connector 30401 herunter. Mallory Ignition Lakewood Subframe Connector 30401 User Manual Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Für das Auto Mallory-ignition Lakewood Subframe Connector 30401