Mallory-ignition Mallory SPARK PLUG WIRE TERMINAL AND BOOT Bedienungsanleitung PDF herunterladen

SPARK PLUG WIRE TERMINAL AND BOOT

INSTALLATION INSTRUCTIONS

STANDARD BOOTS AND TERMINALS

1. Measure and cut the spark plug wire to desired length.

2. Install distributor cap boot on the spark plug wire (see Figure 1). To ease

installation, put a small amount of silicone based lubricant on the spark

plug wire.

3. Strip approximately 5/8" of insulation from the spark plug wire end. DO

NOT cut into the wire conductor core (see Figure 2).

4. Fold the wire core over the outside of the spark plug wire (see Figure 3).

5. Put the terminal on the end of the spark plug wire and crimp the

connection (see Figure 4).

6. Slide the distributor cap boot over the terminal (see Figure 5).

7. Install the spark plug wire between the distributor cap and spark plug.

HEI BOOTS AND TERMINALS

1. Measure and cut the spark plug wire to desired length.

2. Strip approximately 5/8" of insulation from the spark plug wire end. DO

NOT cut into the wire conductor core (see Figure 2).

3. Fold the wire core over the outside of the spark plug wire (see Figure 3A).

4. Put the terminal on the end of the spark plug wire and crimp the

connection (see Figure 4A).

5. Slide the distributor cap boot over the terminal (see Figure 5A).

6. Install the spark plug wire between the distributor cap and spark plug.

NOTE: Any damage to the wire conductor core will cause internal arcing

and destroy the performance of the spark plug wire.

Check the connections periodically. If the connector in the distributor cap

or coil is gray-green (or not shiny), this is evidence of spark-jumping or

a bad connection.

PLACE DISTRIBUTOR

CAP BOOT ON END

OF SPARK PLUG

WIRE

IMPORTANT!

CONDUCTOR MUST BE

WEDGED BETWEEN TERMINAL

BODY AND WIRE INSULATION

FIGURE 1

FIGURE 3

FIGURE 2

FIGURE 3A

FIGURE 5

FIGURE 4

STRIP WIRE AND

BEND AS SHOWN

5/8”

www.malloryperformance.com 1

MALLORY IS A DIVISION OF PRESTOLITE PERFORMANCE

10601 MEMPHIS AVE. #12, CLEVELAND, OH 44144

216.688.8300 FAX 216.688.8306

FORM 1266

Made in China

Printed in China

INSTALLATION INSTRUCTIONS 1

Inhaltsverzeichnis

Seite 1 - INSTALLATION INSTRUCTIONS

SPARK PLUG WIRE TERMINAL AND BOOTINSTALLATION INSTRUCTIONSSTANDARD BOOTS AND TERMINALS1. Measure and cut the spark plug wire to desired length.2. Inst

Kommentare zu diesen Handbüchern

Keine Kommentare

Mallory-ignition Mallory SPARK PLUG WIRE TERMINAL AND BOOT Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Für das Auto Mallory-ignition Mallory SPARK PLUG WIRE TERMINAL AND BOOT herunter. Mallory Ignition Mallory SPARK PLUG WIRE TERMINAL AND BOOT User Manual Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Für das Auto Mallory-ignition Mallory SPARK PLUG WIRE TERMINAL AND BOOT